#Zebra barcode scanner serial#
#Zebra barcode scanner Bluetooth#

However, to configure decoders, reader parameters and other scanner settings, a Bluetooth scanner must be connected.

After initial configuration, a Bluetooth scanner can be enabled and disabled in the Profile, even if it is disconnected from the device.

To initially configure the RS507 in a Profile, the scanner must be paired and connected.When 2D Imager is selected, scanning is performed using the installed Scan or Scan/MSR module.ДataWedge supports the following Zebra Bluetooth scanners:Д«luetooth scanners are supported according to the following rules:.When the camera is selected, scanning is performed with the rear-facing camera.If no Scan Module is installed, the camera is selected.If a Zebra Scan Module or Scan/MSR Module is installed, the 2D imager is selected.The 'Auto' option automatically determines the best scanning device from the list of available devices based on the rules below. The list of available scanners is based on devices present in (or connected to) the unit being configured. The parameters of this feature can be configured using the Set Config API.ДЇor Barcode Input, the Scanner selection panel determines which scanning device will be used for data capture. The raw barcode data that's acquired is processed or formatted as using the Basic and Advanced Data Formatting Processing options that are found near the Output options. DataWedge supports lasers, imagers and internal cameras.

#Zebra barcode scanner serial#

USB synchronous serial interface (SSI) scannersД«arcode Scanner Input reads data from the integrated barcode scanner built into the device, or attached via cable or Bluetooth connection, or implemented as a snap-on module.See the Scanner Parameters section for more information. DataWedge also provides audio and other feedback to alert the user of scanning results and barcode type. Decoders supported by DataWedge are explained below, including commonly used decoders: Code39, Code128, Datamatrix, DotCode, EAN13, OCR A, OCR B, PDF417, QRCode, UPCA, and UPCE. Barcode Input options specify the device hardware to use for scanning and the decoders to be applied on the acquired data before sending it for processing.